CSIA-certified sweeps, same-day service, honest pricing

Chimney sweep near me Pleasant Grove UT

If you've been searching for a chimney sweep near me Pleasant Grove UT, Blackstone Ridge runs CSIA-certified crews through Utah County every week. We brush the flue, pull the creosote, check the cap and damper, and hand you photos of what we found. Most homes in Pleasant Grove are burning 1 to 3 cords a winter, and that's enough to need a cleaning before the cold sets in.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

No spam. No obligation. Just practical help.
Thanks — we'll call shortly to confirm your visit.
Blackstone Ridge — Chimney repair you can rely on
Careful work. Honest options.
About this service

What a chimney sweep near me Pleasant Grove UT actually does

A chimney sweep near me Pleasant Grove UT is a certified flue and firebox cleaning service that removes creosote, soot, and blockages before they turn into a chimney fire or a carbon monoxide problem. We run a rotary chimney sweep and flue brush through the liner, drop a drop cloth over your hearth, and vacuum with a HEPA unit so nothing lands on your carpet. Then we run an inspection camera up the flue and check the damper, chimney cap, and crown.

Pleasant Grove sits at the mouth of Grove Creek Canyon, and the cold air that drains down off Mount Mahogany pushes furnaces and fireplaces hard from October through March. That means creosote buildup happens faster here than in the valley floor towns. If you've been putting off a chimney cleaning near me Pleasant Grove, the shoulder season is the right window - we're booking same-week instead of the three-week wait that hits in December.

  • ✓ Lower chimney fire risk
  • ✓ Better draft, less smoke
  • ✓ Catch problems early
  • ✓ Cleaner air in the house
What's included

What's included in a chimney sweep near me Pleasant Grove UT

A standard sweep covers the flue, firebox, damper, cap, and a visual inspection from the roof. Repairs, relining, and masonry work are quoted separately after we show you what we found. You'll never get a surprise charge on the invoice.

✓

Full flue brushing

Rotary sweep and flue brush run the full length of the liner, matched to your liner material. We brush top-down and bottom-up to get the corners the brush alone misses.

✓

HEPA vacuum and containment

Drop cloths over the hearth and floor, firebox taped shut around the hose, HEPA vacuum running the whole time. Your living room looks the same when we leave as when we arrived.

✓

Firebox and damper check

We vacuum the firebox, test the damper through its full range, and check the firebrick for cracks or gaps. A damper that won't seal gets flagged in the report.

✓

Camera inspection

An inspection camera goes up the flue to check for liner deterioration, gaps at the joints, and creosote we couldn't reach with the brush. You see the footage.

✓

Roof-level check

From the roof we inspect the chimney cap, crown, flashing, and the top few courses of brick. Most leaks we find start at one of those four places.

✓

Written report with photos

You get a plain-English summary of what we found, what needs attention now, and what can wait. Photos included. No upsell on a chimney that's in good shape.

How it works

How our chimney sweep service works

01

Walkthrough

We start inside, at the firebox. You show us how you burn - wood type, how often, whether the damper sticks. We check the damper operation, look for animal nesting, and note any obvious spalling brick or mortar gaps before we set up. Takes about 10 minutes.

02

Containment

Drop cloths go down over the hearth and the floor in front of it. We tape the firebox opening shut around the vacuum hose so nothing escapes. If you've got a wood stove or insert, we pull the baffle and blanket first. This is the step that keeps your living room clean.

03

Sweep and brush

We run a rotary chimney sweep and flue brush up from the firebox, matched to your liner type - poly brush for stainless, wire for clay tile in good condition. Soot and creosote come down into the containment. For heavy Stage 2 glazing, we switch to a rotary whip head.

04

Inspect and document

An inspection camera goes up the flue. We check the chimney cap, crown, flashing, and the top few courses of brick from the roof. You get photos of anything we find - liner cracks, crown damage, a rusted cap - plus a plain-English note on what needs attention now versus what can wait.

05

Clean up and report

We vacuum the firebox, wipe down the glass and surround, and pull the drop cloths. You get a written summary with the photos and any repair recommendations. If everything checks out, we tell you that too - no upsell on a chimney that doesn't need work.

Tools & methods

Tools and methods we use on Pleasant Grove chimneys

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Rotary chimney sweep

Powered brush head that spins inside the flue to knock down Stage 2 glazed creosote that a hand brush can't touch. We match the whip material to your liner type.

Flue brush set

Poly, wire, and nylon brushes in multiple diameters. Poly for stainless liners, wire for clay tile in good condition, nylon for softer cleaning passes.

Inspection camera

Runs the full length of the flue and records footage. This is how we find liner cracks, joint gaps, and creosote we couldn't see from the firebox.

HEPA vacuum

Captures soot and ash at the source so nothing migrates into your living space. We run it continuously from containment setup to final cleanup.

Smoke pen

Confirms draft direction and strength after a sweep. If smoke doesn't pull cleanly up the flue, we keep diagnosing until it does.

Moisture meter

Reads moisture content in brick and mortar. High readings mean water intrusion, which usually points to a crown or flashing problem.

Masonry trowel and jointing tool

For repointing mortar joints and rebuilding crowns. The jointing tool matches the original mortar profile so the repair blends in.

Real results

Before and after.

Three seasons of creosote, one clean flue

Before

A Downtown Pleasant Grove homeowner hadn't swept the chimney in three winters. The flue had Stage 2 glazed creosote coating the upper third of the liner, and the fireplace smoked into the room every time it was lit. The damper was stuck half-open.

After

We ran a rotary whip head through the flue, removed roughly a gallon of glazed creosote, freed the damper, and confirmed draft with a smoke pen. The fireplace lit clean that evening. Total time on site: 2 hours.

Cracked crown stopped a ceiling leak

Before

A Mount Mahogany homeowner noticed a water stain on the ceiling next to the chimney after a January storm. The crown had a hairline crack running across it and the flashing seal had failed. Water was tracking down the outside of the flue.

After

We poured a new crown with crown sealant, replaced the flashing, and applied ChimneySaver waterproofing to the brick. A hose test confirmed no leaks. The ceiling stain was dry within a week.

Bird nest cleared and capped

Before

A Battle Creek homeowner heard scratching in the chimney in early October. A squirrel had built a nest on the smoke shelf and the flue was partially blocked. The first test fire pushed smoke into the living room.

After

We removed the nest, swept the flue, and installed a stainless chimney cap with a spark screen. Draft tested clean. The cap also keeps rain and snow out, which the old setup didn't do.

Problems we solve

Chimney problems we solve for Pleasant Grove homeowners

Most of the calls we get from Pleasant Grove fall into a handful of buckets. If any of these sound familiar, it's time to book a sweep.

Ask a pro →
01

Smoke rolling back into the room when you light a fire

We sweep the flue, test the damper, and run a smoke pen to confirm draft. If the flue is undersized for the firebox, we'll tell you that too and quote a liner sized correctly.

↗
02

Water stains on the ceiling next to the chimney

We diagnose the source - crown, flashing, or cap - and fix it. Most Pleasant Grove chimney leaks trace back to a cracked crown or failed flashing, both of which we repair in a single visit.

↗
03

Creosote smell in the house, especially on warm days

We sweep the flue and remove the creosote load. If it's Stage 2 glazing, we use a rotary whip head to get it back to bare liner. Then we tell you how often to sweep to keep it from coming back.

↗
04

Birds or squirrels nesting in the chimney

We remove the nest, sweep the flue, and install a stainless chimney cap with a spark screen. That's the permanent fix - animals can't get back in once the cap is on.

↗
Proof you can check

Licensed, certified, and accountable

✓
CSIA Certified Chimney SweepChimney Safety Institute of America
✓
NFI CertifiedNational Fireplace Institute
✓
Utah contractor licenseUtah Division of Professional Licensing
✓
Insured and bondedState of Utah
Good questions

Frequently Asked Questions

(855) 927-7517 →

Start by checking for a CSIA Certified Chimney Sweep credential - that's the industry standard and it means the tech passed a written and field exam. Then confirm the company is licensed, insured, and carries a Utah contractor license. Blackstone Ridge meets all three, and we serve Pleasant Grove from Downtown to Mount Mahogany. Call (855) 927-7517 and we'll get you on the schedule.

Most Pleasant Grove chimney cleanings run $180 to $350 in 2026. A single-story home with a standard clay-tile flue and light soot sits at the low end. Two-story chimneys, wood inserts, metal flues, and heavy Stage 2 creosote push toward the high end because they take longer and require different brush heads. We quote the price on the phone before we dispatch.

Yes. We hold same-day slots open most weekdays for Pleasant Grove and the surrounding Utah County towns. Call before noon and we can usually have a sweep at your door the same afternoon. If it's an emergency - smoke in the house, a chimney fire, or a strong creosote smell - we run 24/7 and will get someone out as fast as we can.

Once a year if you burn regularly, and definitely before the first cold snap in October. If you burn more than two cords a winter, or you're burning green or unseasoned wood, you may need a mid-season sweep too. We check creosote thickness during every visit and tell you honestly whether you can stretch to 18 months or need to book again in six.

Ready when you are

Book a chimney sweep near me Pleasant Grove UT today

We're CSIA-certified, licensed, insured, and answering the phone 24/7. Same-day slots are open most weekdays across Pleasant Grove and Utah County. Call (855) 927-7517 and we'll get your flue clean before the next cold front rolls in.

Book My Sweep (855) 927-7517 →
Request an appointment

Get in touch with us

Call (855) 927-7517 any time, day or night, and a real person answers. For non-emergency work, we return messages within a few hours during business hours and can usually schedule an estimate the same week. Tell us what you are seeing and we will tell you what it likely means.

Request received — our team will be in touch shortly.
Tap to call(855) 927-7517