Certified sweeping, real inspections, and honest answers before winter

Chimney sweep Pleasant Grove UT done right the first time

A chimney sweep Pleasant Grove UT homeowners can actually schedule around, Blackstone Ridge cleans and inspects wood-burning fireplaces, inserts, and pellet stoves across Utah County. We pull the creosote, check the liner, and tell you straight what needs fixing now and what can wait. If you have not had the flue looked at since last winter, book before the first cold snap hits.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

No spam. No obligation. Just practical help.
Thanks — we'll call shortly to confirm your visit.
Local Chimney repair team in Pleasant Grove
Careful work. Honest options.
About this service

What a chimney sweep Pleasant Grove UT visit actually covers

A chimney sweep Pleasant Grove UT appointment is not just a brush down the flue. We start by laying drop cloths, then run a chimney brush and flue brush sized to your liner through the full length of the chimney, top to firebox. A rotary chimney sweep handles the stubborn glazed creosote that hand brushing leaves behind. After the sweep, we run an inspection camera up the flue, check the damper, look at the firebox brick and mortar joints, and test the smoke draw with a smoke pen. You get photos of anything we find.

Most Pleasant Grove homes we service were built between the 1970s and early 2000s, and many still run the original masonry firebox with a clay tile liner. That liner cracks over decades of heating and cooling cycles. Add Utah County's dry summers and cold, inversion-heavy winters, and you get mortar that shrinks, spalls, and lets water in. If you have been searching for a chimney sweep in Pleasant Grove, Utah near me and want someone who actually checks the liner instead of just sweeping and leaving, that is the job we do.

  • ✓ Lower chimney fire risk
  • ✓ Better draft, less smoke
  • ✓ Catch liner damage early
  • ✓ Stop water damage cold
What's included

What is included in a chimney sweep

Every sweep includes the full brush-down, a camera inspection, and a written report with photos. Repairs and parts are quoted separately so you only pay for what you approve. Here is what you get on a standard visit.

✓

Full flue brush-down

Chimney brush and flue brush sized to your liner, run top to bottom. Glazed creosote gets the rotary chimney sweep. We pull the damper and clean the smoke shelf and firebox.

✓

Camera inspection

Inspection camera goes the full length of the flue. We check for cracked tiles, gaps, missing mortar, and liner deterioration, and you get the footage in your report.

✓

Crown, cap, and flashing check

We look at the crown for cracks, the cap for rust or damage, and the flashing for failed seals. A moisture meter confirms whether water is getting into the masonry.

✓

Damper and firebox check

We test the damper for smooth operation, look at firebox brick and mortar joints, and check the smoke shelf for blockages. Stuck dampers get noted with a repair quote.

✓

HEPA vacuum cleanup

A HEPA vacuum runs the entire visit, and we lay drop cloths from the door to the hearth. When we leave, the room looks the way it did before we arrived, minus the creosote.

✓

Written report with photos

You get a written summary of what we found, what we cleaned, and what needs attention. Photos of the liner, crown, and cap are included so you can see it yourself.

How it works

How our chimney sweep service works

01

Book and confirm

Call or book online and we lock in a two-hour arrival window. You get a text when the tech is on the way. We work 24/7 for emergencies, and same day chimney sweep Pleasant Grove UT slots open most weekdays during fall.

02

Protect the room

We lay drop cloths from the door to the hearth and seal the firebox opening with a HEPA vacuum running the whole time. No soot trail through your living room, no dust cloud when we pull the brush out.

03

Sweep the flue

We run a chimney brush and flue brush sized to your liner, top to bottom. Glazed creosote gets the rotary chimney sweep. We pull the damper and clean the smoke shelf, then vacuum the firebox and hearth.

04

Inspect and document

Inspection camera goes up the flue. We check the liner, crown, cap, flashing, damper, and firebox brick. A moisture meter tells us if water is getting into the masonry. Everything gets photographed and written into your report.

05

Walk you through it

We show you the photos, explain what we found, and give you a straight answer on what needs fixing now versus what can wait. No pressure, no upsell scripts. If the chimney is clean and sound, we tell you that and leave.

Tools & methods

Tools and methods we use on every sweep

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Chimney brush and flue brush

Sized to your liner and run top to bottom. Poly brushes for clay tile, wire brushes for heavy deposits on masonry flues.

Rotary chimney sweep

Powered rotary head that removes glazed Stage 2 and Stage 3 creosote that hand brushing cannot touch. Used when buildup has hardened.

Inspection camera

Full-length flue footage so we can see cracks, gaps, and missing mortar joints. You get the photos in your written report.

Smoke pen

Tests draft at the firebox after the sweep. Confirms the flue is pulling properly before we pack up.

Moisture meter

Checks whether water is getting into the masonry through a cracked crown or failed flashing. Tells us if waterproofing is needed.

HEPA vacuum

Runs the entire visit to capture soot and dust at the source. No cloud of ash when the brush comes out of the flue.

Masonry trowel and jointing tool

Used for crown repairs, tuckpointing, and mortar joint work during the same visit when the scope allows.

Real results

Before and after.

Four years of creosote, one clean flue

Before

A Downtown Pleasant Grove homeowner had not swept the chimney in four years. Smoke was backing into the living room on cold mornings, and the firebox glass was black within an hour of lighting a fire. The flue had Stage 2 glazed creosote through the middle third.

After

We ran the rotary chimney sweep through the glazed section, then a full brush-down. Camera footage showed the liner was intact. Draft tested strong with the smoke pen. The customer lit a fire that night with no smoke backup and clear glass the next morning.

Cracked crown sealed before winter

Before

A Mount Mahogany home had a visible crack running across the chimney crown. Rain was getting in, and the moisture meter read high on the top three courses of brick. The homeowner had noticed white staining on the exterior masonry.

After

We swept the flue, then ground out the crack and resealed the crown with crown sealant rated for freeze-thaw. A follow-up moisture reading two weeks later showed the masonry had dried to normal levels. No brick replacement was needed.

Bird nest removed, cap installed

Before

A Battle Creek homeowner heard scratching in the flue for a week before smoke started backing up. A bird had built a nest on the smoke shelf, and the flue had no cap. The damper was stuck half-open from debris.

After

We removed the nest, swept the full flue, freed the damper, and installed a stainless steel chimney cap sized to the flue. The whole job took under two hours. Draft tested strong and the damper moved freely.

Problems we solve

Chimney problems we fix for Pleasant Grove homeowners

Most chimney issues start small and get expensive fast. Here are the ones we see most often in Pleasant Grove, and what happens if they are ignored.

Ask a pro →
01

Creosote buildup reaching Stage 2 or 3

We measure buildup during the sweep and remove it with a rotary chimney sweep when it has glazed. If the deposit is heavy, we schedule a follow-up to make sure the flue is fully clean before you burn again.

↗
02

Cracked clay tile liner

We scope the flue with an inspection camera and show you the cracks. Small gaps can sometimes be sealed. Larger damage gets a stainless steel liner sized to your appliance, installed to NFPA 211 standards.

↗
03

Crown cracks and flashing failure

We reseal crowns with crown sealant rated for freeze-thaw, and we pull and reinstall flashing when the roof joint has failed. A moisture meter confirms the masonry is drying properly after the repair.

↗
04

Animal nesting and cap damage

We remove the nest, sweep the flue, and install a stainless steel chimney cap sized to your flue. The cap keeps animals, rain, and snow out for decades with minimal maintenance.

↗
Proof you can check

Credentials and reviews

✓
CSIA Certified Chimney SweepChimney Safety Institute of America
✓
NFI CertifiedNational Fireplace Institute
✓
Utah contractor licenseUtah Division of Professional Licensing
✓
NFPA 211 compliant inspectionsNational Fire Protection Association
Good questions

Frequently Asked Questions

(855) 927-7517 →

Most chimney sweep Pleasant Grove UT jobs run $180 to $350 for a standard masonry fireplace, and $250 to $450 if you have a wood insert or heavy creosote buildup. A Level 2 inspection with camera footage adds $100 to $200. Chimney cleaning cost Pleasant Grove homeowners pay depends mainly on flue length, access, and how much creosote has built up since the last sweep.

A full chimney cleaning Pleasant Grove service includes brushing the flue top to bottom, removing creosote from the smoke shelf and damper, vacuuming the firebox and hearth, and a visual inspection of the liner, crown, cap, and flashing. We run an inspection camera up the flue and give you photos. If we find liner cracks or crown damage, we quote the repair separately.

Once a year if you burn wood regularly, and every two years if you only light a few fires per season. The CSIA and NFPA 211 both recommend annual inspection. Pleasant Grove's dry summers and cold winters accelerate mortar and crown wear, so we recommend a sweep each fall before you start burning. If you burn green wood or a lot of pine, book every year without exception.

Yes. We keep same-day slots open most weekdays, especially from September through December when demand spikes. Call (855) 927-7517 before noon and we can usually get a tech out the same afternoon. Emergency calls after a chimney fire or a sudden leak run 24/7, including weekends.

Ready when you are

Book your chimney sweep Pleasant Grove UT visit today

CSIA certified techs, upfront pricing, and a written report with photos after every sweep. Call (855) 927-7517 or book online and we will get you on the schedule, often the same day.

Book My Sweep (855) 927-7517 →
Request an appointment

Get in touch with us

Call (855) 927-7517 any time, day or night, and a real person answers. For non-emergency work, we return messages within a few hours during business hours and can usually schedule an estimate the same week. Tell us what you are seeing and we will tell you what it likely means.

Request received — our team will be in touch shortly.
Tap to call(855) 927-7517